The Novastar video wall controller H-series products can be used either as a splicing processor with integrated video processing and video control functions, specially designed for fine-pitch LED screens.

The H-Series features an all-hardware slot architecture with high-performance FPGA processing and ultra-high-speed cross-point matrix switching technology to provide powerful signal processing capabilities.

Below is the Novastar H series quick start guide.

1.Click ‘programming’to enter the layer editing interface.

2.The left side shows all input signals: eight 2K input signals and one 4K input signals.They can be switched to thumbnail mode.

3.There are three presets for choice:

(1)Put eight 2K input signals on the screen in two rows and four columns to make the LED screen pixel-by-pixel.

(2)Stretch a 4K input signal to the entire screen.

(3)Put two 2K input signals on the left and right sides, and one 4Kx2K input signal in the center.

4.Drag the input source to the screen to the position coordinates, and adjust the width and height of the image.

5.Follow the same step to add and edit the input images. Then click the ‘Save Preset’button.

6.Set the preset name and click ‘OK’to complete the saving of current presets.

Two other preset procedures are the same as the above operation. You can watch this video to learn to operate. Therefore, you can set up different layouts according to your needs or various used applications.